How to Install 3/4 inch Hardwood Flooring
65
 | Amazon Price: $169.99 List Price: $249.99 |
 | Amazon Price: $175.00 List Price: $199.99 |
 | Amazon Price: $175.99 List Price: $899.99 |
 | Amazon Price: $39.99 |
 | Amazon Price: $3.49 List Price: $8.99 |
Hardwood flooring must be installed over a sub floor of at least 3/4 inch plywood, Advantech sub floor, or 1x12 sub flooring. Particle board and chipboard;(OSB), are not approved sub floors for installing hardwood flooring. These instructions will work for all types of Hardwood flooring including Bamboo, Oak, Hickory, and Maple.
Let the flooring acclimate to the house for a few days before beginning installation. Manufacturers recommend at least three days. Open up as many boxes as possible during the acclimation process.
If in an existing home, carefully remove all baseboards being careful of the walls. Clean the floor completely making sure that all sawdust and wood chips are removed. Check to make sure the sub floor is nailed down tightly against the joists. Nail where needed. Put a layer of 15# felt over the sub floor. This serves as a vapor barrier and also helps prevent squeaks.
From the longest wall which is perpendicular to the joists measure and strike a line with a chalk line the width of a piece of flooring plus 1/2 inch. This will be where your first run will start. The extra 1/2 inch is for expansion. Using a drill and a small bit drill holes in the tongue of the first piece at an angle of 45 degrees approximately 8 inches apart. Use #8 flooring nails to nail the first run down making sure you keep it with the line. When you get to the end wall measure the piece 1/2 inch short to allow for expansion. The piece that is leftover from the cut piece can be used to start the next run. Repeat the same procedure for the second and third runs making sure the pieces are tight against the previous run.
Now you are ready to use the flooring nailer. Lay it one run at a time being careful to lap joints at least 6 inches and nail the flooring down every 6 to 8 inches. The last 4 to 5 runs will have to installed like the first three runs.
TIPS: Clean regularly as you go along. Lay the flooring out ahead of time and do it so the joints overlap saves a lot of time. Oil the nailer regularly throughout the day. I usually oil mine before I start the day and around noon. Get some latex filler that matches your flooring. You can fix any nicks or dings that happen during installation. Latex cleans up easily also.
More Home Improvement
- Hanging Kitchen Cabinets: A How To Guide
Always use extreme caution when using power tools. Injuries happen when directions are not properly followed. Remember also to use eye protection and hearing protection when necessary. Table saws can be dangerous if not used properly. Many fingers... - 3 years ago
- How to Remove Water Stains from Ceilings
So you had a leaky roof a while back and now that it is fixed your ceiling has a gigantic water stain on it. Water stains on ceilings are unsightly but not too hard to get rid of. You cannot actually remove the stain from your ceiling. All that is... - 3 years ago
- How to Repair Walls and Ceilings Using Joint Compound in Cracks
In order to fix cracks in walls and ceilings that are drywalled, one must use tape and joint compound. Take a little joint compound and apply it over the cracks, making sure to get plenty on. Take the paper tape and stick it to the compound making... - 4 years ago
- How to Change a Toilet
Tools needed will be as follows: 1. A flat screwdriver 2. An adjustable wrench 3. A utility knife 4. A pair of adjustable pliers (Channelocks) 5. Hacksaw 6. Rubber gloves 7. A piece of cardboard big enough for the... - 4 years ago
- How to Install 3/4 inch Hardwood Flooring
Hardwood flooring must be installed over a sub floor of at least 3/4 inch plywood, Advantech sub floor, or 1x12 sub flooring. Particle board and chipboard;(OSB), are not approved sub floors for installing hardwood flooring. These instructions will... - 4 years ago
- The Ins and Outs of Bathroom Fixtures
The bathroom is one of the most used room in the house. There are many different styles of fixtures you can use in your bathroom. it all depends on your taste and the style of house you live in. Budget also comes to mind. Generally a bathroom will... - 9 months ago
CommentsLoading...
Thanks for the read and comment Sweetie. You are the first one to comment on this hub but it has been published for many months now.
after you install it sir dent,,,,will you show up time to time to polish it too,,,
Sure will silly, if the pay is good.
thank you for the info it helped me out
How much do you bid on installing bamboo flooring?
It depends on how much flooring there is to be installed.
Was searching for "hardwood floor information", saw your hubpage. Great info on floors and floorings!
Some of us love hardwood flooring because of its simplicity. That's why they put carpets on it to avoid scratches. Carpets are not only protecting the floor. It also adds glam to your interior. So you must give it proper maintenance.
you would be amazed at how many installs i've came across either nailed over particleboard or OSB. personally i'm split since so many new homes are using OSB subfloors and they claim it has a similar bond strength with the nail when you look at its application in roofing. the biggest downfall i can imagine with OSB and hardwood is the creeking. as the staples jiggle loose it's bound to happen and as most of us know if you drive the same fastener in 3/4" ply and 3/4" osb it's harder to pull out of the ply
SweetiePie Level 6 Commenter 3 years ago
Great hub sirdent! Hard wood floors are so beautiful.